Preparation: Always use chemically resistant rubber gloves such as Formby's® Refinishing Gloves and protective eyewear. Work in a shaded, well-ventilated area with temperature ideally between 65º and 85º F. Place a protective drop cloth on the floor of the work area. Before using Formby's® Cleansing Liquid and Buffing Cream on your entire piece, test on an area which is representative of maximum wear or is extremely dull. If the finish or color is lifted, the wood surface needs to be refinished.

Directions: Always read the product label before use

Your Kit Includes:

• 8 oz. Cleansing Liquid
• 7 oz. Buffing Cream -
• 8 oz. Face Lift™ Finish -
• 1 Buffing Pad
• 2 finish Applicator pads

Cleanse:

• Cleansing Liquid gently removes built up dirt and wax
• Shake well before using
• Apply Cleansing Liquid liberally, using the white side of the green and white Buffing Pad. Rub in a circular motion for 20 - 30 seconds to remove built up wax and dirt.
• Use additional Cleansing Liquid as needed.
• There is no need to wipe excess Liquid from the surface
• If you notice that the color or stain is being removed during this step, STOP! The finish is softened or ruined and needs to be refinished. You need Formby's^® Furniture Refinisher.

Buff:

Buffing Cream smoothes away minor scratches and imperfections

• Shake well before using. Using the green side of the green and white Buffing Pad, liberally apply Buffing Cream to a 2-foot square area. Buffing Cream can be applied right over Cleansing Liquid. Buff gently for 2 minutes per area. Use the white side of the Pad for curved surfaces or where the finish is thin. Be careful to buff gently on edges and other areas where the finish is thin.
• Provide additional Buffing Cream as needed.
• Continue process until entire piece has been buffed.
• Lightly dampen a clean cloth and wipe surface to completely remove Buffing residue. Use an old toothbrush to clean out grooves and corners.
• After all Buffing residue has been removed, wipe dampened surface with a dry cloth.
• Allow surface to dry thoroughly for at least 30 minutes.

Finish:

Face Lift™ Finish protects and restores your furniture's original beauty.

• Make sure surface is thoroughly dry and Applicator Pad is clean and free of lint.
• Grasp yellow and white Finish Applicator Pad from the yellow sponge side and thoroughly dampen white side with Face Lift™ Finish.
• Using circular motion, apply a thin, even coat of Face Lift™ Finish to the wood surface. Apply more Finish to the pad and go over the surface again in the direction of the wood grain to remove streaks and lap marks. Allow Finish to dry thoroughly (approximately 4 hours).
• Additional coats may be applied to increase shine. Be sure the first coat has dried thoroughly. Then reapply Finish using the second Finishing Pad provided.

Cautions:

DANGER! COMBUSTIBLE! IRRITATES EYES, SKIN AND RESPIRATORY TRACT. HARMFUL OR FATAL IF SWALLOWED. Before using, carefully read cautions on individual containers. Contains Aliphatic Hydrocarbons and Silica. Keep away from heat and open flame. Use in a well-ventilated area and avoid prolonged breathing of vapors. Avoid contact with eyes. If eye contact occurs, wash eyes with water for 15 minutes and get medical attention. May cause skin irritation. Use enclosed applicator pads to avoid skin contact. Wash thoroughly with soap and water. If swallowed, do not induce vomiting. Get medical attention immediately.

WARNING: This product contains a chemical known to the state of California to cause cancer.

DO NOT TAKE INTERNALLY. KEEP OUT OF THE REACH OF CHILDREN.